This listing is for pre-order Black trim drop spindles - please see the [home page] for estimated shipping times. If you need something sooner, check out the [Instock listing].
Each drop spindle comes with:
1x textured mystery wool mini-batt(approx.14g/0.5oz)
2x ¼” black rubber ring for bobbins
Please note that drop spindles do not come with bobbins as they can be used without one. However, up to 4 bobbins can be bundled with a drop spindle for the discounted rate of $5 each.
The free textured mystery colour wool mini-batt(approx.14g or 1/2oz) is for you to play around with, and test out on your new spindle. In the menu above, you can choose to upgrade to a 56g/2oz mystery batt or to completely remove it should you not want it.
Specs
3d printed with PLA+ trim and bobbins, with PLA whorl cores. Unfinished hardwood dowels. Metal ½” cup hook.
Drop Spindles
Dowel length: 20.2cm / 8"
Dowel thickness: 5/16”
Total length: 24.1cm / 9.5"
Diameter: 7.9cm / 3 1/8"
Weight: 39g / 1.38oz
Bobbins
Length: 9.8cm / 3 7/8"
Diameter: 5.7cm / 2 1/4"
Weight: 7.5g / 0.26oz
Fits any 5/16” diameter dowel
Drop Spindle & Bobbin total weight: 46.5g / 1.64oz
Care Instructions/Warnings
Whorl & bobbins are made of PLA(A renewable plastic made from plant starch). This material begins to warp at 60°c/140°F.
The hardwood shaft is unfinished, and you may choose to paint it or seal it with a wood finish of your choice. If the bobbins are snug, please sand down the wood prior to finishing or they may not fit afterwards.
I recommend practicing over carpet or grass as drop spindles and bobbins in general can be damaged from any drop on a hard surface – especially if they are full of yarn, as that will increase their weight.
Due to the printing process, bobbins can snap if bent or if dropped.