[In-Stock] Bobbins - Black/White

This listing is for bobbins on their own or additional bobbins. Don't forget that you can add up to 4 bobbins per Spindle on the Drop Spindle ordering pages to take advantage of the discounted rate. And if you need o-rings, I have the 1/4" black rubber o-rings listed [here].

Specs

3d printed with PLA+ 

Bobbins
Length: 9.8cm / 3 7/8"
Diameter: 5.7cm / 2 1/4"
Weight: 7.5g / 0.26oz
Fits any 5/16” diameter dowel

Drop Spindle & Bobbin total weight: 46.5g / 1.64oz

Care Instructions/Warnings

Whorl & bobbins are made of  PLA(A renewable plastic made from plant starch). This material begins to warp at 60°c/140°F.

The hardwood shaft is unfinished, and you may choose to paint it or seal it with a wood finish of your choice. If the bobbins are snug, please sand down the wood prior to finishing or they may not fit afterwards.

I recommend practicing over carpet or grass as drop spindles and bobbins in general can be damaged from any drop on a hard surface – especially if they are full of yarn, as that will increase their weight. 

Due to the printing process, bobbins can snap if bent or if dropped.